Journal of the Association of Engineers, India

Bijoy Mandal ¹, Anirban Sarkar ¹, Debashis Biswas ¹, Santanu Das ¹, Simul Banerjee ²

Affiliations
1 Department of Mechanical Engineering, Kalyani Government Engineering College, Kalyani-741235, IN
2 Department of Mechanical Engineering, Jadavpur University, Kolkata- 700 032, IN

Abstract

Conventional fluid delivery system is not much effective to reduce heat generation due to presence of a stiff air layer covering the periphery of grinding wheel. Thermal damages in grinding a super alloy are stringent and problematic. In this paper, a report on the experimental investigation carried out on grinding a nickel based super alloy, Inconnel-600 is made. Different infeeds are considered with dry, wet and wet with pneumatic barrier conditions. To break the stiff air layer covering grinding wheel, high pressure air jet is employed just above the conventional grinding fluid nozzle to facilitate grinding fluid reach the wheel-workpiece interface area. This is termed as a pneumatic barrier. Grinding performance under these environmental conditions has been investigated. Results show better grinding performance with the application of pneumatic barrier in the wet condition as it tends to facilitate fluid reach deep inside the grinding zone effectively.

Keywords

Surface Grinding, Grinding Fluid, Air Layer, Pneumatic Barrier; Grinding Chip, Surface Roughness, Grinding Forces, Flood Cooling Nozzle, Pneumatic Barrier Nozzle, Inconnel-600.

Full Text

     

Bijoy Mandal ¹, Debashis Biswas ¹, Anirban Sarkar ¹, Santanu Das ¹, Simul Banerjee ²

Affiliations
1 Department of Mechanical Engineering, Kalyani Government Engineering College, Kalyani-741235, IN
2 Department of Mechanical Engineering, Jadavpur University, Kolkata-700032, IN

Abstract

High grinding zone temperature often results in several grinding defects. For controlling this, usually large amount of grinding fluid is applied. However, synthetic grinding fluid or cutting fluid has some adverse impact on environment, and, hence, researchers are trying to reduce the application of grinding fluid. In this experimental investigation, a specially developed compound nozzle is used for delivering grinding fluid. Fluid may reach easily into grinding zone at low discharge by using this nozzle. Discharge of the nozzle is about 52% less than conventional flood cooling. Grinding results obtained under different environment are compared. It is found that better grinding performance is obtained by using this compound nozzle than conventional flood cooling grinding; as consumption of grinding fluid is substantially reduced, use of compound nozzle may be more economical and advantageous to control industrial pollution.

Keywords

Surface Grinding, Compound Nozzle, Grinding Fluid, Surface Roughness, Flood Cooling.

Full Text